EPSON EPL-6200 Utility README.TXT

****************************************************
Contents
****************************************************
     1. DISK CONTENTS
     2. ENVIRONMENT SUPPORTED
     3. SETUP
     4. REMOTE CONTROL PANEL UTILITY
*****************************************************

1. DISK CONTENTS
This disk contains the following main programs:
     SETUP.EXE (Installation Program)
     EPRCP.EXE (Remote Control Panel Utility)

SETUP.EXE installs the utility programs. Installation involoves these
two steps:

* Copying and configuring the remote control panel utility
* Modifying your AUTOEXEC.BAT file

EPRCP.EXE lets you set the printer's SelecType functions from your
computer's screen.

2. ENVIRONMENT SUPPORTED

Computer  : IBM PC/AT or compatibles with an 80286 CPU or higher
System    : MS-DOS version 3.3X or later 
Display   : VGA monitor
Memory    : At least 360 KB of available memory
Cable     : An EPSON certified parallel or serial cable

* Also, the printer and computer must be directly connected (these
utilities will not operate on network printers). EPSON does not
guarantee the use of any other cables or re-routed connections through
switch boxes, etc.

A DOS compatible mouse is supported by the remote control panel.
If you prefer to use a mouse, install the mouse driver 
before you start the remote control panel utility.

3. SETUP

Insert the disk into the floppy drive and set the floppy drive to be the
current drive (for example a:\ for floppy drive A). Then type SETUP and
press Enter. The setup program starts, and after that the following
instructions are shown on the computer screen.

4. REMOTE CONTROL PANEL UTILITY

[Usage]
Type the following from the DOS command line.

     EPRCP

* The printer's BI-D setting in the SelecType Parallel B menu must be set
to ON when you use the parallel B interface for the connection.



Copyright (C) 2003 SEIKO EPSON CORPORATION
Nagano, Japan